Posted on March 1, 2019

ELIWELL ID970 PDF

Buy Eliwell On/Off Temperature Controller, 74 x 32mm, NTC, PTC Input, 12 V ac/ dc Supply ID Browse our latest on-off-temperature-controllers offers. Buy Eliwell On/Off Temperature Controller, 74 x 32mm, PTC Input, V ac Supply, → +°C Measurement Range ID V 8A+PTC. Browse our. In order to configure the instrument for this purpose you must access the folder identified by the “Add” label and use the parameters “dEA” and “FAA”. ID LX.

Author: Vudojin Gulmaran
Country: Gabon
Language: English (Spanish)
Genre: Technology
Published (Last): 28 February 2004
Pages: 471
PDF File Size: 9.70 Mb
ePub File Size: 7.46 Mb
ISBN: 918-7-27389-887-7
Downloads: 92407
Price: Free* [*Free Regsitration Required]
Uploader: Bataxe

The two sets are interdependent: Download from reset Connect the copy card when the instrument is OFF.

The same applies to any person or company involved in preparing and writing this document. The relay contacts are voltage-free. The operation cannot be cancelled. Programming parameter transfer from Copy Card to instrument.

Between the request and effective id9970 of the compressor relay, at least the specified time must elapse.

It’s a community-based project which helps to repair anything. Temperature value understood wliwell distance from the Setpoint or as an absolute value based on Att which if exceeded in a downward direction triggers the activation of the alarm signal. ID LX Single stage controller for temperature.

  EL PESCADO INDIGESTO PDF

Eliwell ID MC (Milk) |

It is classified as follows: This means, for example, that an error introduced by the probe is added to any error that is typical of the instrument. At the end of the lamp test, the following messages are displayed for about 5 seconds: Always make sure that the area next to eliwwll cooling openings of the tool is adequately ventilated. Do not exceed the maximum current allowed. For this page to function properly, you must enable JavaScript.

If you do not enable JavaScript, certain features in this eliwel will not function correctly. The device must be suitably protected from water and dust according to the specific application and only be accessible using special tools except for the front keypad.

Eliwell ID970 MC (Milk)

Delay time in activating the outputs after switch-on of the instrument or after a power failure. View with decimal point. ID A Single stage controller for temperature. When enabled value other eliwsll 0it constitutes the access key for level 1 parameters. HSE maximum set cannot be less than LSE minimum set and vice versa Compressor activation time in the event of a faulty probe.

Single stage controller for temperature.

Defrost counting is always active when the machine is on and starts at each power-on. Positive or negative temperature value added to the value read by probe Viewing mode elwell defrosting.

  BADANIE KLINICZNE MACLEOD PDF

Single stage controller for temperature – ID – Eliwell France

At least the indicated time must elapse between switch-off of the compressor relay and the successive switch-on. Single stage controller for temperature – ID The ID controllers are devices suitable for applications on normal or low temperature refrigerating units. Set point setting folder; -Pb1: Always switch off machine before working on electrical connections.

Erasing all parameters in the key.

If one or more parameters are modified, it is suggested to the switch off the controller after the modification and then switched back on. Compressor off time in the event of a faulty probe. ID Single stage controller for temperature. Temperature alarm signal delay time. The programming parameters are downloaded when the device is switched on. Eliwell reserves the right to make any changes or improvements without prior notice and at any time.